高频热合机操作顺序 Operation sequence of high frequency heat - closing machine 　　1. 先接通三相电源总开关，然后打开机台侧控制箱上的电源开关，如果有高周开关的，暂时不打上，接着打上电热电源开关，此时，真空管和热模都开始预热。 1. First through to three-phase power master switch, then open the power switch on the side of the machine control box, if there is a high weeks switch, temporarily not to play, then play in the electric power switch, at this point, the vacuum tube and hot mould are preheating. 　　2. 在下模辅上绝缘物，上极端装上上模，按下试模开关，开始调试上下模接合位置，如果下接合不良，就移动下模，如果水平不合，就调较上模的四支柱子。 2. Insulation on the lower mold and auxiliary and extreme loading up on mold, pressing the test switch, start debugging from mould joint position, if the bad joint and move the lower die, if level, compared with the previous mode is the four pillars of the child. 　　3. 模具调好后，调节三个时间控制器（如果是脚踏型机，只有高周熔接时间），下降时间即上模运行到压紧下模的时间，熔接时间即输出时间，冷却时间，即固化时间，上述三个时间需灵活应用，并无固定值数。 3. After the die set, adjust the three time controller (if it is a pedal type machine, only high weeks welding time), fall time is running under the pressure of upper die mold time, welding time namely output time, cooling time, cure time, the above three time need to be flexible application, there is no fixed number of values. 　　4. 如果第一次调模，需将同调调谐调的间距调到最宽。 4. If the first mode is adjusted, the width of the adjustment should be adjusted to the widest range. 　　5. 以上操作如已超过10－15分钟，且温度也达到所需时，把高周开关打上，开始操作测试。 5. If the above operation is more than 10-15 minutes, and the temperature reaches the required time, the high cycle switch will be hit and the test will be started. 　　6. 测试时，如果效果不理想，需将同调器慢慢加上去，注视屏流表（不同机型该表的值不同，请参考说明书）。检查产品，如果不理想，就把同调器加一点或减一点，直至达到要求。 6. When testing, if the effect is not ideal, you should slowly add the same tuner and look at the screen flow chart (please refer to the instructions for different models of the table). Check the product. If it's not ideal, add a bit or less of the same modulator until it meets the requirements.