生产中出现的各种打火现象处理
Treatment of various ignition phenomena in production
1、 高频模具水平调节一定需要调节水平。
1. The level of High Frequency die must be adjusted.
2、 高频模具出现打火现象一定要用干净的抹布，加上酒精、汽油、甲苯等处理相应的灰尘。
2. If the high-frequency mold is ignited, clean cloth must be used, and alcohol, gasoline, toluene and other dust must be treated.
3、 每次在调试新的模具，电流都应该调整至回0.2A。然后利用同调器慢慢的把电流调至适合的电流热合。
3. The current should be adjusted back to 0.2A every time the new mould is being debugged. Then use the homologer to adjust the current slowly to a suitable current for thermal bonding.
4、 高频模具下面必须采用一定的绝缘材料。有效地防止高频再次击穿所需要的焊接产品。
4. Some insulating materials must be used under the high frequency mold. Effectively prevent the high frequency breakdown of the required welding products.
5、 电容片在调节过程中不应该调节的过于猛烈，应当慢慢的调试相应的范围，电容片在生产过程中边缘出现打火现象，可能是电容片的边缘没有处理干净又铝板毛刺。需要用砂纸处理打磨光滑。
5. The capacitor should not be adjusted too violently in the process of adjustment, and the corresponding range should be adjusted slowly. The edge of the capacitor is ignited in the production process, which may be that the edge of the capacitor is not cleaned and the aluminum plate is burred. Sanding is required.
6、 振荡桶在生产过程中出现的打火现象主要有电容片，高压管座等跳火。处理方式和电容调节片一样。
6. In the production process of the oscillating barrel, the ignition phenomena mainly include the capacitor, high-voltage socket and so on. It is treated in the same way as the capacitor regulator.